MITSUBISHI
Home >> Download >> MITSUBISHI >> Manual Download >> MITSUBISHI A3NMACA16-UL Manual A3NMACA16-UL User's Manual

MITSUBISHI A3NMACA16-UL Manual A3NMACA16-UL User's Manual

Brand: MITSUBISHI
Product model: A3NMACA16-UL
Name: PLC
Sort: User's Manual
File language: English
File size: 0.41MB
Input type: DC input, positive public end / negative public end.
Input points: 16 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/5mA.
Output form: transistor output, leakage type.
Output points: 16 points.
OFF leakage current: 0.1mA.
Output protection function A3NMACA16-UL Manual A3NMACA16-UL User's Manual.
Rated load voltage / current: DC12V/DC24V/0.1A A3NMACA16-UL
External connection: 1 line /1 line type.
40 pin connector type (FCN connector type).
Through the 40 pin connector type (FCN connector type) can be connected to a variety of devices.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong A3NMACA16-UL Manual A3NMACA16-UL User's Manual.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer A3NMACA16-UL Manual A3NMACA16-UL User's Manual. Multi axis positioning controller.
Coaxial data communication line function.
Program capacity: Max 60K step.
Input / output points: 1920 points.
The number of I/O thyristor DC motor control required tube DC motor speed control system is the main form of DC speed regulation,
The thyristor rectifier unit is used to supply power to the DC motor.
PLC control of the DC drive system, the input of the PLC in addition to the main signal outside the signal,
We need to consider the switching signal, the fault signal transmission device, brake signal and fan faullt signal A3NMACA16-UL Manual A3NMACA16-UL User's Manual.
The output of the PLC mainly consider the speed command signal positive 1~3 level, 1~3 level, allowing reverse switching signal and brake open signal etc..
In general, a reversible DC drivee system controlled by PLC is approximately 12 input points and 8 output points,
An irreversible DC drive system requires 9 inputs and 6 output points A3NMACA16-UL Manual A3NMACA16-UL User's Manual.
Related products