Home >> Products >> MITSUBISHI >> FX series PLC >> FX3G series >> FX3G-14MR/ES-A | MITSUBISHI PLC FX3G-14MR/ES-A


MITSUBISHI FX3G-14MR/ES-A Manual And Instructions
FX3G-14MR/ES-A datasheetPDF datasheet
FX3G-14MR/ES-A Hardware EditionUSER'S MANUAL
FX3G-14MR/ES-A Basic & Applied Instructions EditionPROGRAMMING MANUAL
FX3G-14MR/ES-A MODBUS Serial Communication EditionUSER'S MANUAL

MITSUBISHI FX3G-14MR/ES-A Product information and technical parameters:
Name: PLC
Model: FX3G-14MR/ES-A
Input points: 8 points.
Output points: 6 points.
Power supply voltage: AC100-240V.
Output type: relay output.
Built in CPU, power supply, input and output. While maintaining the convenience of FX1N while improving performance.
Special adaptor and function expansion board can be installed and used FX3 series.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function.

Function: CPU module.
Input and output points: 32 points.
Power supply capacity (DC5V power): 720mA.
Power supply capacity (DC24V service power supply): 500mA.
Input / output mode: DC input (drain / source) / transistor (source).
Input points: 16 points.
Output points: 16 points.
Expansion module is more compact, more suitable for small devices!
Small body on the collection of many functions MITSUBISHI FX3G-14MR/ES-A FX3G-14MR/ES-A
FX5UC can be connected to the expansion module, compact and convenient,
Suitable for all kinds of small equipment.
Through the rich conversion module,
Can freely connect FX5 and FX3 expansion devices. Total input and output points: 40 points.
Input points: 24 points.
Output points: 16 points.
Output type: transistor output MITSUBISHI FX3G-14MR/ES-A.
Power supply voltage: AC100-240V.
Input signal voltage: DC24V.
8K capacity of the RAM memory, the maximum can be extended to 16K.
CPU arithmetic processing speed of 0.08 S/ basic instructions.
On the right side of the FX2N series can be connected to the input and output expansion modules and special function modules.
The basic unit is built in the 2 axis independent maximum 20kHz positioning function (transistor output type) MITSUBISHI FX3G-14MR/ES-A.
Quick disconnect the terminal block, which adopts excellent maintainability to quickly disconnect the terminal blocks, even if the cable is then replaced by the cable.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application of the continuous scan time.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017).
Note recording function, Component annotation can be recorded in the program rregister FX3G-14MR/ES-A.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program FX3G-14MR/ES-A.

...More relevant models >>>>